Rocklin and Sacramento Auto Repair

We've all been there.  You park your vehicle on a steeper than usual hill and worry about it rolling down while you're running your errands.  So you decide you'll use the parking brake.  When you get back, you release the parking brake, hit the ignition, put it in gear and—uh, oh—you can feel the parking brake is still on.  It's stuck.  What do you do now? Welcome to the world of infrequently-used parking brakes.  Yes, they do stick for several reasons. It's common for components to corrode and get locked up.  Sometimes if you have applied it extra hard, it can jam.  Could be a rusty cable, could be a spring that doesn't return the brake to its disengaged position.  Some pieces just break when they're stressed for the first time in a while. A caliper or the pivot arm it's on can also stick. There are a few things you can try to unstick it.  Carefully rock your vehicle by putting it first in drive and then reverse.  You ... read more

We usually take our vehicle's easy steering for granted until something goes wrong.  Power steering is what makes it almost effortless to turn the steering wheel, aiming your vehicle in the direction you want to go. Without the assistance of power from the engine, steering would be a laborious process, so you want to make sure the system is working well. Power steering systems are usually one of two types, hydraulic and electric.  The hydraulic type uses a pump that is driven by either a belt or an electric motor.  This system uses hydraulic fluid to create pressure that gives your steering the power assist.  Since that pump is always working, time and distance traveled eventually take their toll, and these systems need to be periodically inspected.  Also, while that hydraulic fluid can last for years, it should be replaced periodically as it degrades over time. Your vehicle's owner's manual contains the manufacturer's recommendations. A technician can check fo ... read more

A driver of a large SUV loaded with equipment was heading on a 7-hour work trip when he stopped at a gas station to refuel.  When he went to restart his SUV, it turned over but wouldn't catch.  Try as he might, he was never able to get it started again.  Of course there are many things that can cause those symptoms, but the next day he had his SUV towed to a service repair facility.  Using their test equipment, they were able to pinpoint the problem.  His fuel pump had failed.  The pump, which was located in the fuel tank, had to be replaced, and after awhile he was back on the road, delayed, but happy to be up and running again.  What had happened is that the pump was not strong enough to deliver adequate  fuel to his engine, vital to being able to start it.  It had delivered just enough pressure in the morning to get it started the first time, but it was on its last legs.  He had been having trouble starting his SUV in the days leadin ... read more

There are some dashboard lights you should pay more attention to than others.  One is the air bag light.  If it's on and your vehicle is in an accident, your air bags probably won't do their job. Automakers began installing air bags in the late 1990's since they were mandatory in the United States, and manufacturers have included them in Canadian vehicles as well.  Safety experts say using a seat belt in combination with an air bag gives passengers the best chance of surviving a crash and minimizing serious injury. The air bag warning light takes a few different forms.  Some look like a picture of a belted passenger with an inflated air bag from a side view.  Or there may be a warning light that says something like "Air Bag," "SRS" (for supplemental restraint system), "Airbag Deactivated" or "Air Bag Off." Different things cause the air bag light to come on.  Your vehicle may have been in an accident during which, while the air bags didn't inflate, crash s ... read more

You've just arrived at the store shopping and you're ready to head home.  You put your key in the ignition and… oh, no! The ignition won't turn! What do you do now? Don't panic.  There are some things you can do to get going again.  The first thing to do is see if you have a locking steering wheel, an anti-theft feature that was introduced around 1970.  Sometimes it sticks.  Move the steering wheel side to side while you try to turn the key and you might be able to get it to release.  Another thing to check is to see if your vehicle is in gear.  Most vehicles will only allow you to start the ignition if it's in park or neutral.  If you have an automatic transmission vehicle and it is in park, try jiggling the shift lever and try the key again.  Sometimes the safety mechanism doesn't properly make contact or gets a little sloppy.  If both of these don't work, it could be your vehicle's battery is dead.  Some newer electronic ... read more

Know anyone who doesn't love a power seat in an SUV, a car, truck or van? They're convenient and precise in their adjustments.  But when they break, oh, what a pain.  Not only is it inconvenient, it may leave your seat position too close to the steering wheel or too far from the pedals.  This is a must-fix problem. There are many things that cause a power seat to fail: Seat controls.  These are either at the side of the seat or in the door.  Both are places that can be exposed to moisture or other contaminants.  When the controls stop working, they usually need to be replaced. Seat motor.  Electric motors are what make a power seat move, and sometimes they fail.  Sometimes they just get worked to death and die of old age.  Replacement is the most common remedy. Fuses. A power seat is, after all, powered by electricity and all vehicle power systems have fuses to protect them.  A technician can determine which fuse may have blown and rep ... read more

If your windshield wipers are streaking and chattering when you turn them on in the rain or snow, it's time for a little "blade renewal." And when it comes to new wiper blades, there are some new designs that are worth a look. One of the latest is called the beam blade.  It's different than conventional blades you might be used to.  Instead of a metal frame and a rubber blade that slides in the frame on a track, the beam blades have an enclosed spring-steel band that allows the rubber wiper to conform to the windshield glass shape much more tightly.  There are some key advantages to beam blades, which is why many vehicle manufacturers are making them standard on their latest models.  For one thing, they work well in all weather conditions, including the heat of summer and the icy, snowy cold of winter.  Since there is no separate frame, snow and ice can't form in gaps like conventional wipers and prevent the blade from clearing your windshield.  Many beam ... read more

You may remember a song that went, "Objects in the rearview mirror may appear closer than they are." While that was a song about life's lessons, there are a few things we should all know about how important rearview mirrors are to safe driving. While new electronic devices are helping drivers be aware of surrounding traffic in high-tech ways, the good old rearview mirror is still a dependable way of letting you know what's around you.  There are usually 3 on each vehicle, 1 attached to the windshield inside and 2 attached outside on each of the front doors. It's important that they be adjusted properly before you start driving (not while you're driving). Experts say the windshield rearview mirror should cover the area behind the vehicle while the outside mirrors should not simply duplicate that view but extend it to the sides, where blind spots normally are. Your rearview mirrors must be able to hold the positions they're adjusted in; it there's play in them or they move around, y ... read more

Automatic transmissions rule. The old days of shifting your own gears are a thing of the past for most drivers.  But automatic transmission trouble can be a big inconvenience for any driver if it comes at the wrong time in the wrong place.  Here are some signs to look out for that may mean you are having transmission issues. When you are driving, your vehicle seems to slip in an out of gear without you touching anything.  That's what some call, not surprisingly, a "slipping transmission."  When your vehicle shifts from one gear to the next, you hear a loud "clunk." Transmissions are supposed to be nearly silent when they shift, so that noise is telling you something is wrong.  If you notice there's a puddle of some fluid under your vehicle, your transmission could be leaking fluid.  Try to figure out what color it is (try putting a piece of cardboard underneath to capture some of the fluid).  If it is red or brown, that's a sign it could be transmissi ... read more

There are some boots that don't come in a shoe box and aren't worn on your feet.  They are called axle or CV boots, and they can be important parts for many vehicles. That CV stands for constant velocity.  CV axles are mainly used in front-wheel drive and all-wheel drive vehicles. They're also used in some rear-wheel drive vehicles with independent suspensions.  They have two CV joints, one inner and one outer, placed between the axle and the drive wheels.  That way the vehicle's engine power can drive the wheels, no matter what angle they are.  They also adjust for the different speeds wheels turn as they go around corners.  Because roads are full of all sorts of hazards (dirt, oil, water, grime), these CV joints need to be protected.  They also have grease in them to keep the bearings moving smoothly.  That's the job of the rubber boots that are supposed to keep that debris out.  These CV or axle boots are made of rubber or plastic and usu ... read more