Rocklin and Sacramento Auto Repair

Talk about exquisite choreography; it happens under the hood of your vehicle every time you take a drive.  Your engine’s many complex parts must work exactly together.  One key is a part called a timing belt, which enables the synchronizing of two of your engine’s components, the camshaft, and the crankshaft.   The timing belt coordinates the valves in your engine to open and close at the appropriate time to get exhaust out of the engine’s cylinders. Timing belts may also power the water pump and the oil pump.  The belt is made of rubber.  Some engines use a timing chain (made of metal).  Your vehicle’s manufacturer recommends an interval after which you should have your timing belt or chain replaced, and that service should be part of your vehicle’s regular maintenance.  It’s always better to replace it before it breaks rather than after.  After all, if your timing belt breaks while you’re driving down t ... read more

The internal combustion engine in your vehicle counts on two things that mix together to be burned in the engine for power: fuel and air.  Both are important, of course.  If you run out of fuel, your engine won’t run at all.  Since there’s plenty of air around, you won’t run out of air, but you could feel your vehicle’s performance suffer if the engine air filter starts to get clogged.  It's important that the air that enters your engine be free of dirt, dust, and debris to prevent damage to internal components.  That’s where the engine air filter comes in.  It prevents those particles from entering the engine, an important job that most people just take for granted. After a while, your air filter will get dirty, which results in less air reaching the engine.  Modern fuel injected engines can adjust the amount of gas to mix with the air that is getting in, so your fuel economy won’t change significantly.  What ... read more

If your vehicle’s power goes to the rear wheels, then you have something called U-joints in the drivetrain. U-joints are connectors that allow the rotating power from your vehicle’s engine to deliver its power through a driveshaft to make the rear wheels rotate.  You need U-joints because the surfaces you drive on aren’t perfectly flat, and the driveshaft has to allow for some flexibility when you are traveling over uneven surfaces. As you can imagine, the U-joints have to move and flex a lot as your vehicle is going down the road.  They have bearings in them to allow that flexibility, and those bearings are lubricated when your vehicle is made.  Some U-joints have lifetime lubrication and are not designed to be serviced.  When they fail, they have to be replaced.  Others have grease fittings on them that need periodic lubricating by a technician at intervals recommended by your vehicle’s manufacturer.  There are signs you can look ... read more

Few of us ever drive somewhere without encountering some pretty rough roads, and it's amazing how well our vehicles are able to smooth out the ride. Thank your shocks and struts. The two parts are similar.  Some cars have shocks in the rear, and struts in the front.  Others have struts all around.  A shock absorber uses a cylinder filled with gas or liquid that's connected to your vehicle's frame and axle.  When your vehicle encounters an imperfection in the road, the shock dampens the motion.  A strut is essentially a shock absorber mounted inside a spring and can support more weight than a shock by itself. Shocks and struts take a lot of punishment and wear out.  When they do, your tires are not contacting the road as much as they should, and that can result in a bumpy, unstable ride. Worn-out shocks and struts also transfer the impacts of road imperfections directly to your vehicle's body which can cause further damage to other parts. You can tell when ... read more

Tires are so reliable these days that few drivers pay much attention to them.  But tires wear out.  They have a tough job since they are the only point of contact between your vehicle and the road.  They have to get your vehicle going from a stop, keep it going, make sure it is headed in the direction you want it to go, and –importantly – slow and stop it.   The only time many drivers think about their tires is when there's a problem, such as a flat.  Or, they may lose control when they find their vehicle isn't stopping or steering like it used to.  One major safety organization estimates that 1 out of every 11 crashes is related to a tire issue.   Many of those problems are caused by tire tread wearing out.  The rubber is worn off by friction after hours and hours on roads.  The sidewalls can also be damaged by your tires hitting curbs, potholes, or other debris. Plus, rubber ages as time passes.  We recommend you let us in ... read more